![]() ![]() Use these settings at your own risk.Īll multiplier settings appear to be 10K-Ohm Warning: All information for PowerBook G5s is completely untested. PLL 0 is set to 1 if 19, R20, and R21 are not jumped.Īll voltage locations require 0-Ohm resistances. D4 is set to 1 if only R126 is jumped.Įxample: PLL 0 is set to 0 if R19, R20, or R21 is jumped or if any combination of R19, R20, and R21 are jumped. ![]() ![]() Example: D4 is set to 0 if only R757 is jumped. When the only resistor on the right side of the chart is jumped, the pin is set to 1. When only the resistor on the left of the chart is jumped, the pin is set to 0. D0, D3, and D4 are on the front of the logicboard. BOM0 is set to 1 if R641 is jumped.Īll voltage locations require 0-Ohm resistances. For example, BOM0 is set to 0 if R623 is jumped. A BOM will not function properly if both of its locations are jumped. A BOM is set to 1 if its 1 location is not jumped. ![]() All BOM resistors are 10K-Ohm.Ī BOM is set to 0 if its 0 location is jumped. Warning: All bus speed modification information for PowerBooks is completely untested. PLL 0 is set to 1 if R43, R44, and/or R48 are not jumped. A PLL is set to 1 if none of the PLL's locations are jumped.Įxample: PLL 0 is set to 0 if R43, R44, or R48 is jumped or if any combination of R43, R44, and R48 are jumped. All multiplier locations require 0-Ohm resistancesĪ PLL is set to 0 if one or more of the locations are jumped. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |